wholesale fashion jewelry and hair accessories How to knot the bracelet

2 Comments / By

wholesale fashion jewelry and hair accessories

2 thoughts on “wholesale fashion jewelry and hair accessories How to knot the bracelet”

  1. Cedric

    thailand monogram jewelry wholesale First, the auspicious knot
    The ear wings of the auspicious knot are just seven, so it is also called "seven -circle knots". This knot often appears on the clothing and temples of Chinese monks and temples. It is an ancient and considered auspicious knot, so it is named "auspicious knot". The auspicious knot is the extension of the cross knot, and it is also one of the ancient decorative knots, which means auspicious auspiciousness.

    first 4 ears

    Thexicular 1

    4
    Ear 4 through the hole in the ear 1

    tightened the body, and at the same time, the ears should be left
    and in the same way, and the knot of the clockwise along the clockwise clockwise again.

    In 4 ears that are out of the extra, and it will be completed.
    . Vajrayana
    is said to be a amulet, and many people wear King Kong knots on their bodies. It is said that King Kong can bring good luck to us.

    . The tail of the phoenix
    The phoenix tail knot is also known as the fortune knot, eight -character knot, which is generally used for the ending of the Chinese knot, which plays a decorative effect, symbolizing the dragon and phoenix, the business, and the financial resources.

    . The flat knot
    is the oldest, most popular and most practical cable. "Ping" is equal to high and low, and does not mean the same as above and down. At the same time, it also has the meaning of conquest and stability, such as flatness and ingenuity.
    Is to see other people's clever bracelet knots, are you envious? Is it troublesome to change the rope and get the store to ask someone to wear it? No need, auspicious knots, King Kong knots, phoenix tails, flat knots, four ways to knot, let you edit and make it.

  2. Antoinette

    stone jewelry wholesale india How to knot the bracelet

    1. In addition to the bracelet that needs to be knotted, you also need to prepare a section of silk threads with the same color material as the bracelet. First, put the two ends of the bracelet together and align. Note that the space of the two sections of the bracelet should not be reserved too little, as shown in the figure at this time.

    2, and then the prepared additional wire thread passes through the inside of the bracelet, and the wire thread is used as a knot on the bracelet as a fixed silk thread.

    3. After the knot is knotted, you will find that there are three stories of lines, namely the wire line and the bracelet of the bracelet. Essence

    4, next, pass through the wire wire on the right side from the lower end of the bracelet line, and pass through the upper above the left wire wire. Note that the direction of crossing the right wire must be correct, otherwise the knot will easily fall off.

    5, then, then pass through the thread on the left side of the bracelet, and then wear it from the bottom to the bottom, from the inside to the outside.

    6, after passing through, tighten the left and right lines, as shown in the figure below. Note that don't pull too tightly at this time, otherwise the bracelet will not be adjusted.

    7, then similar to the above steps. At this time, starting from the right line, the right wire on the right side is passed through the upper above the bracelet line and below the left line. Also pay attention to the direction of crossing.

    8, then pass through the left line from the bottom of the bracelet line. After coming out of the right line, tighten the left and right lines again.

    9. The above knot is knotted as a cycle. Next, repeat the above steps in turn, then tighten, and after 3 cycles, you will complete the bracelet red rope. The ending was knotted.

Leave a Comment