planet silver wholesale jewelry bangkok thailand How to DIY handmade beaded beads drawing carton method diagram

tous jewelry imitation wholesale first. Preparation raw materials include: No. 6 nylon line and acrylic (or crystal) beads. If you feel that it is painful by the thread, it is best to prepare a pair of gloves. first step. Start from the bottom, cut a section 6 nylon line, the length may be 4 meters (beginners can be shorter). See the picture below, and wearing four beads online, that is, the left and right lines are kept about two meters. Secondly. Hold the line on the left hand, grab the right hand from behind the left hand line to the front (direction from right to left), after getting around, then wear the last bead (direction from right to left), then left and right after wearing it. Tighten up with both hands (reminded: the two lines have to contact the node of the two lines to pull it to the center of the bead, so that the beads will be fixed very firmly). third step. Oh, the first little flower is done. See Figure 3, and the high -rise building is flat. The entire box has a lot of small flowers. Therefore, it is difficult, wonderful, and beautiful. the fourth step. Then wear one capsule with your left hand and two string in your right hand. the fifth step. The right hand line is wrapped from the back line from the left hand to the front (the direction from the right to the left), and after getting around, then wears the last bead on the right hand side (prompt: 1. Don't wear the front one, the direction from right to left; 2. The bead of the left hand is under the cross nodes of the two lines. The number of beads dressed has changed). Step 6. In this case, the little flower was born, see the picture below. Step 7. Next, like the fourth and fifth steps, wearing beads first, and then tightening around the winding, so that the ten groups are pushed through ten groups (so the bottom is vertical, and it comes out). Step 8. After wearing the tenth group, you will be bent at this time. You do n’t wear beads in your left hand and three capsules in your right hand. The movement is the same as the two steps and the fifth step. Three beads get the last one. Tightened after wearing it. Step 9. After the cornering, the method is still the same as the fourth and fifth steps. One capsule is worn on the left hand and two capsules in the right hand. After wearing it, refer to the picture. Step 10. Next, this type of push through four groups. After wearing it (when you come out of the bottom, you come out), you will turn around. The turning is the same as the eighth step. 9. Step 11. Then continue to wear another vertical side, the way to wear is the same as the 4th to seventh steps in front. After wearing it, you must turn around. After the cornering is done, continue to do another horizontal edge. The approach of horizontal side is the same as the ninth to the tenth step. (Summary: This step is to be vertical and horizontal. The method is the same as the two other edges in front.) Step 12. I did all the four edges, prepared to connect, see Figure 10, the left hand line passed through the one bead on the top of the vertical side, and the right hand line was wearing two beads. Tight, just have the first floor at the bottom.