designer fake jewelry wholesale What are the steps of handmade beads and paper towel boxes

designer fake jewelry wholesale

1 thought on “designer fake jewelry wholesale What are the steps of handmade beads and paper towel boxes”

  1. chinatown new york city wholesale jewelry first step. Start from the bottom, cut a section of No. 6 nylon line, about 4 meters in length (beginners can be short). See the picture below and wear four beads online, that is, the length of the left and right lines is about two meters.

    Step 2. Hold the line on the left hand, grab the line on the right hand from behind the left hand line to the front (direction from right to left), after getting around, then wear the last bead (direction from right to left) on the right hand side, left left and right after wearing it out of the left and right Tighten up with both hands (reminded: the contact nodes of the two lines should be pulled to the center of the hole in the bead, so that the beads are fixed very firmly).

    The third step. Haha, the first little flower was done. From the high building, the whole box was made up of many small flowers. Therefore, the mountains and rivers are hard, wonderful, and good -looking.

    The fourth step. Then wear one capsule with your left hand and two string in your right hand.

    Step 5. The right hand line is wrapped from the back of the left hand to the front (the direction from the right to the left), and after bypasses, then wear the last bead of the original right hand (remind: 1. The last one of the two beads on the right hand, Don't wear the front one, the direction from right to the left; 2. The bead of the left hand is under the cross node of the two lines. The number of beads has changed).

    Step 6. The second little flower was born.

    Step 7. The next step is the same as the fourth and fifth steps, first wear beads, and then tighten the winding around, so as to push the small flowers such as ten groups (then the vertical edge of the bottom comes out).

    Step 8. After wearing the tenth group, you will start to bend at this time. You do n’t wear beads in your left hand and three capsules in your right hand. The action is the same as the two steps and the fifth step. The last one. Tightened after wearing it.

    Step 9. After the cornering is done, the approach is the same as the fourth and fifth steps. One capsule is worn on the left hand and two capsules are worn on the right hand. Next, push through four groups, and after wearing (the bottom of this bottom, the bottom of the bottom) starts to turn. The operation of turning is the same as that of the eighth step. R n
    Step 11. Then continue to wear another vertical edge at the bottom. The method of wearing is the same as the method of the fourth to seventh step in the front. After wearing it, start the cornering. The method of turning the corner is the same as the eighth method. After the cornering, continue to do another horizontal side, the approach of horizontal side is the same as the ninth to tenth approach. (Summary: The vertical edge and horizontal side of this step are the same as the two other methods in the front).
    Step 12. In this way, all the four edges are ready to prepare the connection. See Figure 10, the left hand line passes through the one bead on the vertical side, and the right hand line is wearing two beads. Tighten up, so the first layer of the bottom is just fine.

    Step 13. Start expanding the bottom, see Figure 11. The left hand line passes through the inner hole of the vertical beads in the direction of the orchid line in the picture in the picture. Go around, then wear the last one of the three beads in the right hand (see the yellow circle label in Figure 11), and then tighten your left and right hands. The prompt to receive the second step is the same.

    Step 14. Next, wearing two beads in the right hand. The method of wearing is the same as the second step, but the second step is empty. This step is directly through the back of the line between the two beads that I just passed by the left hand just now. The last one of the two beads on the right hand, and then tighten your hands.

    Step 15. Follow the 14th step to continue the vertical edge

    Step 16. After the fifteen steps are edited, the horizontal edge is started. The method of wearing the left hand line is the same as the 13th step. The right hand line wears three beads. (Reminder: From the second lap of the bottom to the end of the entire box, the left hand line is no longer wearing beads, but the change of the right hand line is changed. Pass in the beads of the row and play a fixed effect.)

    Step 17. In this way, the other two vertical edges and horizontal edges expanded at the bottom can be woven according to the method of step 13 to 16. The preparation of the entire bottom is over. (Reminder: At the end of the end, you must wear two beads on your right hand.)

    Step 18. Let's start with the sides of the box, (remind: the basic wear of pearls, you can see the second and fifth and thirteenth steps. In the future steps, I will not be in Ao Shi. The key point I will explain Wear a few beads.) Next, wearing three beads on the right hand and wearing the boxes on both sides depends on the color matching. If there is no change in color, and this tutorial is a more complicated strawberry flower shape, so At first, the order of the right hand was wearing one white first, and then two grains of red.

    Step 19. Continue to move forward, first wear a grain of red beads in the right hand, and then wear a white bead (two in total).

    The second 20. Next, push the right hand in order to wear two beads. When it is red, it is replaced with red beads. Others use white beads. You can look at the position of the picture bead. When you arrive, you can replace it with colorful beads. Looking at the pictures in this way is more intuitive. Compared with some paper drawing on the market, it is easier to determine the position of the beads, so this real is the best instructor.

    Theteenth steps. In this way, the first layer of the box side (the four sides of the box) must be edited. At the first layer of the contact, the right hand is only needed to wear a grain of beads, and then it can be edited according to the basic wearing method.

    It 22. The second layer on the side of the box is exactly the same as that of the first layer. The difference is that the color of the beads used in the flower type is different.

    It 23. The side of the box is compiled five floors. The other four layers and the first layer are exactly the same. As long as you pay attention to the change of the flower type, the change of the flower type can be referred to the second 20.
    It 24 steps. After wearing the five layers, the next step began. The first layer of the top layer was the same as the wearing method of the fifth layer on the side of the box. It was also first wearing three beads on the right hand line. The order was two white and one green. The left -hand line passes through the hole in the last row of beads from the fifth layer of the side.

    . Next, wear two beads in the right hand and make it forward in turn. When the first layer of the top is woven to the turning point, the right hand line can be worn by a bead. The marked place is where everyone should wear on the right hand. After wearing it, the turning on the top is done. (Reminder: Every corner of the top is wearing a bead, and then wearing two beads again).

    Step 26. After the first layer of the top layer is done, continue to wear two beads on the right hand to make forward. At the end of the first floor, the left hand line is wearing the method. Basic wear method, wearing two beads.

    Step 27. The second layer of the top layer is the same as the first layer, and I will no longer describe it. When the second layer of the top is woven to the end, the changes have occurred again. Next, see Figure 30. The orchid line is the way to wear the left hand line, and the red line is the way to wear the right hand line. According to the figure shown in the figure, it is tightened.

    Step 28. Next, the edge operation on the top is began. See Figure 31, the orchid lines and the red line represent the left hand line and the right hand line, respectively. Show in the middle yellow circle), began to wear two beads, and then cross with the orchid line. You can wear the basic way of wear.
    Step 29. After taking the above step, the right hand line continues to wear two beads (according to the basic wear of the beads). When the vertical edge is about to turn around, the right hand line is only wearing one bead.

    . Then do not wear beads when turning around. Next, the two lines are the same as the 28th step. The two threads pass through the hole in the bead of the horizontal side. When there are two beads at the corner, the right hand line starts to wear two beads. Essence
    31. The right hand line pushs two beads in order. At the end of the end, see Figure 33, and then wear a bead on the right hand line (according to the basic method of wear).

    Step 32. I think of this step, everyone should know what to do, just take the left and right lines in the beads a few more circles, how beautiful and how to wear it. The line, the red line is the right hand line. Just cross the left and right hand lines, and then put it back to tighten it.

    Okay, finally, I believe that everyone will have some difficulties at the beginning, but once they are familiar with the method, they will become faster and faster, because there are many in the same place in them. After editing one, you can be able to integrate, and you can make a beautiful and practical moonlight treasure box in the future.

Leave a Comment